Responsible For An Peugeot 308 Key Fob Budget? 10 Fascinating Ways To Spend Your Money

· 4 min read
Responsible For An Peugeot 308 Key Fob Budget? 10 Fascinating Ways To Spend Your Money

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be somewhat old-fashioned but it's still appealing. It might not be the most luxurious car in its class - it's a Ford Focus or Volkswagen Golf will isolate you even better from sloping surfaces - but it's a relaxing and civilised driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can help whether the problem is intermittent, or constant.

Water Damage

If you accidentally drop your key fob in a puddle, or if it is wet while kayaking, canoeing, rafting or canyoning, the fob is likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry bag when you're outdoors or performing activities in which the fob may be exposed to large amounts of water.

You'll also want to ensure that the fob is completely dry prior to opening it and using it again. If you notice any odors emanating from the fob such as an industrial-type smell or a sour taste like windshield washer fluid, it's another sign that it's submerged in water.

A circuit board that's damp can cause the battery's charge to drop its energy or even explode. If you can pull your 308 keyfob out of the water it is best to turn the button side up and shake as much water as possible before opening the casing. After opening it, take off the battery and wipe down the circuit board with an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could stop working include the battery of your coin is dead problems with the receiver module, signal interference, or a faulty electronic chip. If none of these are the problem you can reset the system by disconnecting a 12 Volt battery from the car for 15 mins.

Dead Coin Battery

Peugeot cars are equipped with remote start that allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the car before they get in. This feature is extremely helpful, especially during cold winter months. However, sometimes the remote stop system stops working due to a variety of reasons, such as a dead coin battery.

A coin-shaped battery that is in the key fob has a lifespan of two to four years, based on how frequently it is used and where it's purchased. The date for use-by will be printed on the package or in the user's manual.

If the key fob has stopped working after being exposed clean tapwater, take out the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If you expose it to soapy or salty water, the chip could be damaged and you'll have to replace the key fob completely.

If you're not certain the battery is in good condition it is possible to test the voltage with an instrument set to the car's voltage range and connected to the terminals for minus and plus. The voltage should read approximately 12-13 volts, but if it's lower, the battery needs to be replaced. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should begin to run after this.

Faulty Receiver Module

If you're not getting the "Key Detected" message on your dashboard, then it's possible that your receiver module has discovered a problem. It's the part that transmits a signal to the car when the key fob is activated, which acts as an immobiliser, and stops it from starting until the correct key is used.

This could be due to a range of factors including water damage or simply ageing. If the chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water it could be due to the fact that the keyfob was exposed to it. In this scenario you'll have to take it apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. Once it's dry, you can put the battery back in and try it again.

If the issue persists, it is recommended to consult the local Peugeot expert or locksmith. They'll make use of a diagnostic device to help pinpoint the issue and repair it for you.


It is stressful to lose your Peugeot car key. A qualified auto locksmith will be able to resolve the issue within minutes. They can cut a new key and then program it into your vehicle, making sure you're ready to get on the road again in the shortest amount of time. Find a locksmith near you.

A malfunctioning electronic chip

The electronic chip that is in your Peugeot 308 key fob is an vital component of the remote control system. If it is damaged, your car might not start or you might receive a message stating "anti-theft active". In this scenario the only option is to replace the key. Auto locksmiths who are professionals can provide this service within the shortest possible time.

The chip inside the key fob of your Peugeot 308 could be damaged due to various reasons, such as sweat, water damage or dirt. If your Peugeot key fob has been exposed soapy or dirty water, it needs to be cleaned immediately. You can wipe the electronic component using a paper towel soaked in isopropyl Alcohol. After  peugeot car key replacement cost , let the battery dry completely.

Radio interference can cause the key fob to stop working. This can be caused by other devices that operate at the same frequency as your Peugeot key fob. This could be due to bad conditions or objects in the vicinity of the vehicle. It is recommended to see a Peugeot dealer in the event of this issue.

The Peugeot key fob 207/308 is very delicate and requires a lot of attention. It should not be dropped or throw it around. If you lose something, try to find it as soon as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Make sure you disconnect the negative first, and then the positive.